Відео

I had thought of this method when creating spiral threads was always misaligned (not straight). Thank you.

Thank you!!!! It was exactly what I was looking for!

If it is a sliding window, how to install it?

Great idea! Glass is used for 16 grit sandpaper with formaldehyde resin

Better with no music

Great idea. Thank you for sharing.

Very useful video, send link for materials where we can purchase

What are the frames made from please put info on what is used.

GOD BLESS you sir! You may have just saved my tractor because I must make a stud for the engine to save it since the studs are DISCONTINUED. THANKS SO MUCH.

"simple solution" well i'm only 10 seconds in and it's defo more simpler going to the shop an buy the gun THUMBS DOON

Super

THANK YOU VERY MUCH VIDEO WHERE IS AVAILABLE MATERIAL

Excellent...👍👍👍👍👍

I wonder if I can fit a 4-40 in that?

Great tutorial. I have to cut an unusual thread for an older saw and want it to be straight.Thank you.

Me apka subscriber hu me aapki har video dekhta hu

Bhai aapko ye bechna hai to muje dedo na

or... get an aluminum can top cutter (the kind that cuts the inside, not the outside), cut a can, and you've got a perfectly good can cup. Make a pot cozy for it, and it's both insulated, and you're able to hold it in your hand with boiling hot liquid inside. That's what I use as a cup when backpacking. I've also made countless alcohol stoves with aluminum cans (some with the razor method, some with a inner cutter for the top, and some with the outside cutter).

Pomyslowe.

Wooow when is rivet long shorten it. What agreat idea. Never seen before...

you used some type of grease instead of a fluid. what was it?

when are you gonna make the drill from the reciprocating saw? Subbed just to wait for that masterpiece.

Easier, less expensive to get a caulk gun 😔. Time searching for all the parts needed from hardware store, getting there an back, putting it together, etc. Nice hack for very well supplied professionals.

Verry good... ❤

Please send the link to buy this type of aluminium section

Magnifique.... Espectacule ...merci e vous amicci

Super😊

Gi mana cara mesan

An idea but glass all over my workshop doesn't sound good. Would some mettle oxide be safer?

No thanks

Don't be silly, wear protection gloves.

The music is groovin. What is the trailer for?

Very nice beautiful ❤️❤️❤️❤️🪚🪚🪚🪚

What is the name of that tool

just get the right size rivet!!! time is money...

Question: Since the Rivet Base begins to deform (shorten) immediately when you begin to compress the "nail", is there some way to 'begin' compressing the Rivet at an angle (like the one shown in the vid) and then "straighten out" the installation tool once the below-surface nub has shortened enough to be swung to the Vertical? Or is the Rivet component deformed at an angle that won't allow correct 'attachment' of the two surfaces?

Wouldn't use the word simple.. But I get the gist.. just push something into the bottom

Brilliant!

👏👏👏👏👏👌 all products link please

Very good idea Sir🎉

Very clever

great customization

Когда коту делать нечего,,,

Thank you very much brother for uploading very useful video 👌

para ser experimental funciona muy bien ., debería patentar

Wow very good idea love that

This is a great idea to tread a crank shaft on a predator 22hp motor and keep it straight

I just want the upper frame bhai where can I get this

Bhai i need this frame only where can I get

Bad idea